Beerlabel of 55x90mm. Suitable for smaller bottles or cans.

A label with the size of 75x100mm.

A label sized 140x72mm. Suitable for bigger bottles.

Round stickers of 90mm (diameter). The stickers can be printed up to the edge, but avoid frames / borders on the outside of the sticker, with a small shift of the image position this immediately has a disturbing effect.

You can specify a different size here (width x height in mm). You enter the final size that must remain after trimming (without bleed) or finishing (folding, binding, etc.) or finishing (folding, binding, etc.)

You can specify the diameter, from small to large. Enter the final size which remains after cropping, without bleed.

Stickers are printed on white polyester (glossy) and are suitable for outdoor use. The stickers stick to the surface directly and are difficult to remove, glue will remain after removal. We do not recommend to use this standard sticker material for long term use or for use on objects that will be exposed to rough conditions.

Environment: PET (PVC free)
Properties: GlobalTAC film matt white, 58µm thick / 75 grams, 88% opacity.

Stickers are printed on sticker material from Paperwise organic kraft paper, which are (partly) made from agricultural waste. Moreover, the glue is fully compostable, so this sticker is very friendly to the environment. The color is beige and gives a natural look. The surface is mat and rough and not water resistant.

Environment: Made of 100% agricultural waste, BioTAK adhesive (compostable), EN13432 certified
Properties: Paperwise Natural, 95µm thick / 70 grams, EC1935/2004 and FDA certified

Stickers will be printed on sticker material of white paper. The surface is matt and rough, comparable with office paper. Is widely use as labesl for wine / beer bottles. The material is not water-resistant.

Environment: Made of 100% agricultural waste, BioTAK adhesive (compostable), EN13432 certified
Properties: Paperwise White, 104µm thick / 75 grams, EC1935/2004 and FDA certified

Stickers are printed on silver metallic polyester (matte finish). This material is of premium quality and provides a luxurious look. Thanks to its non-reflective surface, you get clear and vibrant color reproduction. It is suitable for short-term outdoor use. Our printers can print the stickers in any color without losing the metallic effect. However, please note that due to the metallic layer, colors may appear slightly different in tone.

Environment: PVC-free polyester material
Properties: Canon IJM762, 100µm thick / 127 grams, 98% opacity

The stickers will be incised and delivered on a sheet (there are multiple stickers on 1 sheet).

The stickers will be cut out per piece and have a peeling edge so you can easily remove the sticker for the back sheet.

Your document will be cut on the contour lines. Please note, this is an "expert" option: it is fairly complex to provide this properly in your file. Deliver your document with a separate layer for the contour lines. Look here for instructions.

The contour lines are visible as a blue line in the preview. If the contour lines have not been delivered correctly, a message will appear. Don't see an error? Then you did well!

Complex figures (many sharp corners/very small forms) are difficult to produce and therefore this is not possible.

No round corners.

A small rounded corner of ø3,5mm.

A medium rounded corner of ø7mm.

A large rounded corner of ø9,5mm.

A very large rounded corner of ø20mm.

There will be no glossy coating added on the product.

The front will be coated. The coating is a transparent top layer that provides extra shine and protection. You should not see this as a lamination layer, because the coating is formed by transparent toner that seals the paper and the print.